One End Reinforced Submarine Single Carcass Hose 1st From PLEM or Buoy
Tail Full Floating Hose Main Carcass:
- Main Lining / Inner Tube: Smooth, oil and fuel resistant Pure Seamless and Extruded Acrylontrile-Butadiene-Rubber (NBR);
- Safety Lining: special construction to prevent defects or damage cause by incidental tearing or superficial damages of the main linig;
- Reinforcements: Multiple Plies of High Tensile Textile cord. One embedded helical Body Steel wire.
- Cover: Black Syntetic Rubber Smooth oil and fuel resistant.
- Single Carcass And Double Carcass
Product Details
Tail Full Floating Hose Construction & Material
Tail Full Floating Hose Main Carcass:
- Main Lining / Inner Tube: Smooth, oil and fuel resistant Pure Seamless and Extruded Acrylontrile-Butadiene-Rubber (NBR);
- Safety Lining: special construction to prevent defects or damage cause by incidental tearing or superficial damages of the main linig;
- Reinforcements: Multiple Plies of High Tensile Textile cord. One embedded helical Body Steel wire.
- Cover: Black Syntetic Rubber Smooth oil and fuel resistant.
- Single Carcass And Double Carcass
Tail Full Floating Hose Floatation:
- Floating Material : Closed cell Foam. Tail Full Floating Hose Outer Cover:
- Smooth black, Synthetic Rubber Resistant to Abrasion, Oil, Sea Water and Sunlight.
- Helical Orange strip.
- Polyurethane Orange in Colour cover available on request.
Tail Full Floating Hose Fittings: End connections built in during manufacture. ASME B 16.5 Class 150lb or 300lb Weld Neck Flat Face or Raised Face on request.
Tail Full Floating Hose Tests: All tests according to GMPHOM 2009 and Customer detail.
|
 |
 |
| Gel Chromatography | Tensiometer Display | Wire Torsion Tester |
 |
Inspection
 |
 |
 |
| 1. Material Tests | 2. Adhesion Tests | 3. Buoyancy Recovery Test |
| In addition to the quality control tests that the Manufacturer will have in place for compounds and materials listed in the following table, the following Material Tests should be conducted every three months. | The adhesion strength between all composite plies of the hose Body will be determined by peel testing in accordance with ISO 36 using strip test pieces. The measured adhesion strength will be not less than 6 N/mm. | Adhesion tests will also be conducted on the integral buoyancy medium at three monthly intervals. The sample will have a minimum internal diameter of 300 mm and will be at least 500 mm long. |
 |
 |
 |
| 4. Weight Test | 5. Collar Test | 6. Torsion Test |
 |
 |
 |
| 7. Tensile Test On Pressurized Hose | 8.Dynamic Test Bending Load | 9./10. Minimum Bend Radius Test/Bending Stiffness Test |
 |
 |
 |
| 11. Hydrostatic Pressure Test | 12. Kerosene Test | 13. Vacuum Test |
 |
 |
 |
| 14. Electrical Test | 15. Burst TestDouble Carcass Burst Test | 16. Lifting Lug Acceptance Test |